Pool Filter Cleaning in Port Aransas, TX

PoolServ cleans pool filters for homeowners across Port Aransas and Mustang Island, where direct Gulf salt spray crusts over cartridge elements and beach sand loads up DE grids every windy afternoon. Our locally owned team soaks, hoses, backwashes, and recharges every filter type so your water circulates clear and your pump stops straining against salt-clogged media.

Cartridge Filter Cleaning

We remove the cartridge elements, hose off debris, and soak them in a filter cleaner to break down oil and grime. This restores flow and extends the life of your cartridges so you do not replace them as often.

DE Filter Grid Cleaning

DE filters use fine grids coated in diatomaceous earth to capture tiny particles. We take the filter apart, clean each grid, check for tears, and recharge with fresh DE powder so your filter catches everything.

Sand Filter Deep Clean

Sand filters need backwashing and an occasional deep clean to remove trapped oils and calcium. We backwash, then run a filter cleaner compound through the sand bed to break down buildup that backwashing alone cannot remove.

Pressure Gauge Check

A clogged filter shows up as high pressure on the gauge. We check the pressure before and after cleaning so you can see the difference. If your gauge is stuck or broken, we replace it so you always know your filter status.

Filter Inspection and Repair

During every cleaning we inspect the filter tank, clamp band, multiport valve, and internal parts for cracks or wear. If we find a torn grid or a cracked cartridge, we point it out and explain your options before any work begins.

Filter Media Replacement

When filter sand goes bad or cartridges wear out, we replace the media with quality materials matched to your filter model. Fresh sand or new cartridges restore filtering power so your water clears faster and stays balanced.

Pentair, Hayward, and Jandy Filters

We clean and service pool filters from Pentair, Hayward, and Jandy, the three brands found on most pool pads on Mustang Island. Our team knows the internal layout of each model line, from Pentair Clean and Clear Plus cartridges to Hayward ProGrid DE filters and Jandy CL filters. We bring the right cleaning tools and replacement parts for each brand.

For cartridge filters, we carry replacement O-rings, manifold caps, and clamp bands. For DE filters, we bring fresh DE powder, grid sets, and air bleed tubes. For sand filters, we carry filter cleaner compound and replacement sand in the right grade. That means most cleanings finish in one visit without a return trip.

Waterway, PacFab, and Other Brands

We also clean and service filters from Waterway, PacFab, and other brands common in older island pools. These filters use the same basic principles but have different internal layouts and part sizes. Our team takes the time to inspect each component and source the right replacement if something is worn or cracked.

If your filter is undersized for your pool or past its service life, we will tell you honestly and explain your options. A filter that is too small for your pool volume will clog fast and struggle to keep up. We can help you size a replacement if that time comes.

We Assess the Filter

Our tech checks the pressure gauge, inspects the filter tank and valve, and notes the filter type and condition. We tell you what we see before we start cleaning so there are no surprises.

We Send a Written Quote

You get a clear written quote before any work begins. We explain what the cleaning covers, whether any parts need replacing, and your options. No pressure, no surprise charges after we start.

We Clean and Verify Flow

Once you approve, we disassemble the filter, clean every component, and reassemble it. We check the pressure gauge and return flow to confirm the filter is working right before we pack up.