Pool Equipment Repair in Corpus Christi, TX

PoolServ provides expert pool equipment repair for homeowners across Corpus Christi and the Coastal Bend. Our locally owned team fixes heaters, filters, salt cells, lights, valves, plumbing, and automation so your pool runs like it should.

Pool Heater Repair

Heaters that will not fire, cycle on and off, or throw error codes need a trained eye. We check the burners, igniter, pressure switch, and heat exchanger to find the fault and get your water warm again.

Pool Filter Repair

A filter that leaks, will not hold pressure, or has a cracked tank or bad multiport valve starves your pool of clean water. We repair and replace filter parts to restore flow and clarity.

Salt Cell and Salt System Repair

If your salt system shows a low chlorine warning, the cell may be scaled or worn out. We clean or replace the cell, check the control board, and test the sensors so your chlorine production stays steady.

Pool Light Repair

A pool light that flickers, trips the breaker, or has water in the niche is a safety issue. We replace bulbs, lenses, transformers, and fix the wiring so your pool is safe and lit at night.

Pool Valve and Plumbing Repair

Leaking valves, cracked pipes, and air leaks on the suction side reduce flow and can damage your pump. We repair and replace valves, plumbing, and skimmers to keep water moving the right direction.

Pool Automation and Control Repair

Automation systems that lose connection, show blank screens, or fail to control pumps and heaters need specialized diagnosis. We test the control board, relays, and wiring to restore full control.

Pentair, Hayward, and Jandy Systems

We repair pool equipment from Pentair, Hayward, and Jandy, the three brands that make up most pool systems in the Coastal Bend. Our team carries common parts like multiport valve gaskets, pressure switches, and salt cell cleaning solution so many repairs happen in one visit. We know the part numbers and common failure points for each model line.

For heaters, we service Pentair MasterTemp and UltraTemp, Hayward Universal, and Jandy JXi and Lite2 models. For automation, we work on Pentair IntelliCenter and EasyTouch, Hayward OmniLogic, and Jandy iAqualink. We read the error codes and test each component before recommending a fix.

Salt Systems, Lights, and Filters

We repair salt systems from Pentair IntelliChlor, Hayward AquaRite, and Jandy AquaPure. These systems have cells, control boards, and flow sensors that each fail differently. We test the cell output, check the board for fault codes, and inspect the sensor before we recommend replacing any part.

For pool lights, we work on Pentair IntelliBrite, Hayward ColorLogic, and Jandy WaterColors LED systems. For filters, we service cartridge, DE, and sand filters from all three brands plus Waterway and PacFab. We source quality replacement parts that match your equipment so the repair lasts.

We Diagnose the Equipment

Our tech inspects the failed equipment, checks error codes, tests electrical connections, and traces the problem to its source. We tell you exactly what is wrong before we recommend a fix.

We Send a Written Quote

You get a clear written quote before any work begins. We explain the parts needed, the labor involved, and your options. No pressure, no surprise charges after we start.

We Complete and Verify the Repair

Once you approve, we complete the repair and test the equipment under load. We confirm the heater fires, the filter holds pressure, and the system runs clean before we pack up.